How to Use
- A dispenser method and pin transfer method are used to supply the paste to the gold electrode on the circuit board.
- After mounting the device (gold electrode), bonding is possible in 20 minutes without applying pressure by raising the temperature to 200°C (0.5°C/sec.). Bonding is possible in air or gas atmosphere and no washing is needed after bonding.
- Additional heating at 200°C for about one hour is effective for increasing the bonding strength.
Comparison of Durability from Differences in Bonding Material
- LEDs were flip-chip bonded to a metal circuit board using AuRoFUSE™ with gold-tin solder and silver-tin-copper solder. A LED module was created by mounting 12 LED elements connected in series of two rows. Subsequently, a thermal stress test was performed by applying a load of 24V at 350mA and turning the LEDs on and off (load time was 15 minutes). The results demonstrated a high bonding reliability of the LED devices connecting to gold particles.